- Tunnels
- Tunnel code (E): in tanks, Prohibited in E; in other carriage, Prohibited in E. Every category except E. (ADR 8.6.4; from the ADR table itself)
- Small-load exemption
- Transport category 2: at most 333 per transport unit under 1.1.3.6, counted ×3 toward the 1,000-point limit (ADR 1.1.3.6.3; from the ADR table itself)
- Labels
- Labels: model 6.1 (Toxic substances) (ADR 5.2.2.2.2, label model No. 6.1; paraphrase, not yet reviewed)
- Packing
- Packing instruction P002: General packing instruction for solids: combination, single, composite packagings and pressure receptacles, with net mass limits by packing group. Packing instruction IBC08: IBC08 is the widest solids IBC instruction: metal, rigid plastics, composite, fibreboard 11G, wooden and flexible 13-series IBCs. Packing instruction LP02: Solids in large packagings: glass, plastics, metal, paper or fibre inners in 50-series or 51H outers, packing group III only, up to 3 m3. Packing instruction R001: R001 permits light gauge metal packagings 0A1 and 0A2 up to 40 l / 50 kg for packing groups II and III; packing group I is not allowed. Special packing provision B3: Flexible IBCs must be sift-proof and water-resistant, or carry a liner that is. Mixed packing provision MP10: Up to 5 kg per inner packaging may be mixed with same-class goods of other codes, other classes that permit it, or non-ADR goods. (ADR 4.1.4.1, P002, 4.1.4.2, IBC08, 4.1.4.3, LP02, 4.1.4.1, R001, 4.1.4.2, IBC08, B3, 4.1.10.4, MP10; paraphrase, not yet reviewed)
- Tanks
- Portable tank instruction T1: Portable tank, Class 1 and 3–9: test 1.5 bar; shell See 6.7.2.4.2; relief Normal; bottom openings See 6.7.2.6.2. Portable tank provision TP33: The assigned tank instruction covers granular/powdered solids and solids loaded hot but carried as a solid mass. Tank code SGAH: ADR tank code for Classes 1 and 3–9: solid tank, G (general minimum), openings A, hermetically closed. — S: tank for solid-state substances (powdery or granular); G: minimum calculation pressure under the general requirements of 6.8.2.1.14; A: filling or discharge openings at the bottom, each with 2 closures; H: hermetically closed (see 1.2.1) Tank provision TU15: Tank must not be used to carry foodstuffs, articles of consumption or animal feeds. Tank provision TE19: Top fittings recessed, valved or shielded against overturning; bottom fittings recessed 200 mm or rail-protected; rear fittings behind the 9.7.6 bumper. Vehicle for tank carriage: AT — Tank vehicle for dangerous goods that is not EX/III, FL or a MEMU: tanks over 1 m³ / 3 m³, or battery-vehicle over 1 m³. (ADR 4.2.5.2.6, portable tank instruction T1, 4.2.5.3, TP33, 4.3.4.1.1, tank code SGAH, 4.3.5, TU15, 6.8.4 (b), TE19, 9.1.1.2, AT vehicle; paraphrase, not yet reviewed)
- Carriage
- Bulk carriage VC1: Bulk carriage allowed in sheeted vehicles, sheeted containers or sheeted bulk containers (BK1 also usable if 7.3.3.2 met). Bulk carriage VC2: Bulk carriage allowed in closed vehicles, closed containers or closed bulk containers (BK2 also usable if 7.3.3.2 met). Bulk provision AP7: Bulk carriage is permitted only as a full load. Loading provision CV13: After a leak or spill, clean (and if needed disinfect or decontaminate) the vehicle or container before reuse; check other goods for contamination. Loading provision CV28: Pointer: the provisions of 7.5.4 apply. Operation provision S9: Any quantity: avoid service stops near inhabited or busy places; longer stops there need authority consent. (ADR 7.3.3.1, VC1, 7.3.3.1, VC2, 7.3.3.2, AP7, 7.5.11, CV13, 7.5.11, CV28, 8.5, S9; paraphrase, not yet reviewed)